Hip&Ridge&Starter​ SHINGLAS Green Mix
Close
Aesthetic appearance of ridges, easier installation of eaves, maximum protection against wind, snow and rain loads. Roof tiles consist of three equal segments, each segment is fixed with four nails. On the eaves, whole shingles are used, while for the ridge and the hip of the roof, each shingle is divided into three segments.
Read more
Hip&Ridge&Starter​ SHINGLAS Grey Mix
Close
Aesthetic appearance of ridges, easier installation of eaves, maximum protection against wind, snow and rain loads. Roof tiles consist of three equal segments, each segment is fixed with four nails. On the eaves, whole shingles are used, while for the ridge and the hip of the roof, each shingle is divided into three segments.
Read more
Hip&Ridge&Starter​ SHINGLAS Brown Mix
Close
Назначение: эстетичное оформление коньков, облегчение монтажа карнизов, защита от максимальных ветровых, снеговых и дождевых нагрузок. Черепица состоит из трех равных сегментов, каждый сегмент крепится на 4 гвоздя. На карниз гонт используется целиком, на конек и ребро, гонт делится на три сегмента.
Read more
Hip&Ridge&Starter​ SHINGLAS Red mix
Close
Назначение: эстетичное оформление коньков, облегчение монтажа карнизов, защита от максимальных ветровых, снеговых и дождевых нагрузок. Черепица состоит из трех равных сегментов, каждый сегмент крепится на 4 гвоздя. На карниз гонт используется целиком, на конек и ребро, гонт делится на три сегмента.
Read more
Components
No matter what materials are used for roof construction, there are some assemblies and parts that are likely to cause concern and therefore require close attention. Roofing is no exception. Some time ago, a reinforced roof covering and makeshift parts made of materials at hand were used to address this issue.

Today, everything is much easier: manufacturers of this type of construction materials also produce special parts, vents, and water drains for certain areas of concern.

These roofing components are made of PVC, EPDM, or polyethylene, and this is why their installation procedure differs in many ways. For example, EPDM or polyethylene components are installed on polymer and asphalt roofs using gas burners while PVC components are installed using deposit welding or hot-air welding.